Fault Finding

A-Lift (vertical lift with shaft)

  • Check emergency stop is turned on.
  • Check main power switch is turned on.
  • Check key switch is turned on.
  • Check sensitive edge. If the lift meets an obstruction, it will stop immediately.
  • Are the doors Closed, if not Close the door.
  • If the lift only moves 100 mm from the floor it can bee a door lock contact that’s not is looked. Try to close the door so the door contact will bee close.
  • If the lift has stopped in the down direction it can bee the over speed governor. Call Globus!

B-Lift (vertical lift with out shaft)

  • Check emergency stop is turned on.
  • Check main power switch is turned on.
  • Check key switch is turned on.
  • Are the doors Closed, if not Close the door.
  • If the lift only moves 100 mm from the floor it can bee a door lock contact that’s not is looked. Try to close the door so the door contact will bee closed, or the dorrlook can bee frozen try to take away the ice and put some grease on the door look.
  • If the lift only moves up but not down check the sensitive edge under the platform. It can bee ice on them or it can bee fasten in, the in position.
  • If the lift not moves all the way down. Check if it´s stone, snow or ice under the platform.
  • If the lift has stopped in the down direction it can bee the over speed governor. Call Globus!

Chair Lift (Always park the lift at the charging station when you don’t use the lift)

  • Check emergency stop is turned on.
  • Check main power switch is turned on.
  • Check key switch is turned on.
  • Check the seat swivel is turned in the look position for travel.
  • Check sensitive edge. If the lift meets an obstruction, it will stop immediately.
  • Check the rail hinge is fully closed position for travel.
  • If the lift has stopped in the down direction it can bee the over speed governor. Call Globus!
  • Check if the battery power is running low in the remote controls. Replace the batteries.
  • If the lift moves very slowly try to hand winding the lift to the charging station to charge the batteries for at least 24 hour.

Wheel chair Lift (Always park the lift at the charging station when you don’t use the lift)

  • Check emergency stop is turned on.
  • Check main power switch is turned on.
  • Check key switch is turned on.
  • Check sensitive edge. If the lift meets an obstruction, it will stop immediately.
  • Check that the arms are in the down position (test to make put soft pressure on the arms).
  • Check that the flaps are in the up position.
  • Check if the battery power is running low in the remote controls. Replace the batteries.
  • If the lift moves very slowly try to hand winding the lift to the charging station to charge the batteries for at least 24 hour.